Nokia 4A0-265 Exam Dumps - Actual Questions Answers

1-Day PMs are one of the types of PM data that can be retrieved from an optical network element. 1-Day PMs show measurements collected over the preceding 24 hours, with each hour being a bin. Up to 8 bins are available for data storing, which means that only the most recent 8 hours of data can be accessed. The other types of PM data are 15-Minute PMs, which show measurements collected over the preceding 15 minutes, with each minute being a bin, and Total PMs, which show measurements collected since the last reset of the PM counters. References: Nokia Optical Diagnostics and Troubleshooting Course, Nokia 1830 PSS-32 and PSS-16 Photonic Service Switch Release 8.0 Performance Monitoring Reference Guide

A “Loss of Signal” (LOS) alarm is a critical alarm that indicates that there is no or very bad signal at the physical interface. LOS alarm is also raised when the signal level drops below the threshold, at which a high bit error rate (BER) is predicted. LOS alarm can be caused by physical damage, power outage, or misconfiguration of the equipment. LOS alarm can affect the service availability and performance of the optical network. Therefore, it is typically assigned a critical severity level, which means that it requires immediate attention and resolution2. Other severity levels are major, minor, and warning, which indicate different degrees of impact and urgency of the alarms. References: Troubleshooting Guide for Cisco NCS 1002, T1: A Survival Guide, M-series SONET/SDH alarms and troubleshooting tips

 The statement that an “Incoming SUPVY LOS” alarm is raised on the local node is NOT a characteristic of an Optical Supervisory Channel Loss of Signal (OSC LOS) issue, in case that no “LD Input LOS” alarms are raised against the involved amplifiers. An “Incoming SUPVY LOS” alarm indicates that the input signal of the Optical Supervisory Channel (OSC) is lost or below the threshold6. The OSC is a bidirectional channel that connects two adjacent nodes in a DWDM network and carries OAM information and other services7. An OSC LOS issue can occur due to a fiber cut, a defective or dirty OSC fiber, or a faulty OSC transmitter or receiver8. However, if there is no “LD Input LOS” alarm raised against the involved amplifiers, it means that there is no loss of signal on the line interface of the amplifier, which carries both service channels and OSC channels9. Therefore, an “Incoming SUPVY LOS” alarm on the local node is not related to an OSC LOS issue, but rather to an OSC configuration issue or a faulty OSC card10. References : Nokia Optical Diagnostics and Troubleshooting Course | Nokia, Optical User Guide - Nokia, Alcatel-Lucent 1830 PSS-8 and PSS-16 Photonic Service Switch