Juniper JN0-335 Exam Dumps - Actual Questions Answers

• A stateful firewall in SRX Series devices keeps track of the state of network connections, distinguishing legitimate packets for different types of connections and allowing only packets that match a known active connection. Sessions are created when a TCP SYN packet is received and permitted by the security policy1.
• A security policy is a set of rules that defines how traffic is processed by the SRX Series device. A security policy applies the security rules to the transit traffic within a context (from-zone to to-zone) and each policy is uniquely identified by its name. The traffic is classified by matching the source and destination zones, the source and destination addresses, and the application that the traffic carries in its protocol headers with the policy database in the data plane2.
• A Layer 3 route is a path that a packet takes to reach its destination based on the destination IP address. The SRX Series device performs a longest-match Layer 3 route table lookup to determine the next hop for the packet3.
• An Application Layer Gateway (ALG) is a software component that provides application-level awareness, security, and control for specific protocols. An ALG inspects the application-layer payload of a packet and modifies it if necessary to allow the application to traverse the SRX Series device. For example, an ALG can rewrite IP addresses and port numbers in the payload of FTP or SIP packets4.
• The sequence that an SRX Series device uses when implementing stateful session security policies using Layer 3 routes is as follows3:

References:

• 1: Traffic Processing on SRX Series Firewalls Overview | Junos OS | Juniper Networks
• 2: Best Practices for Defining Policies on High-End SRX Series Devices - TechLibrary - Juniper Networks
• 3: [SRX] Example: Configuring TCP SYN Check options on a per-policy basis
• 4: Application Layer Gateways Overview | Junos OS | Juniper Networks

Adaptive Threat Profiling is a feature that allows SRX Series Firewalls to generate, propagate, and consume threat feeds based on their own advanced detection and policy-match events. This feature enables you to configure security or IDP policies that, when matched, inject the source IP address, destination IP address, source identity, or destination identity into a threat feed, which can be leveraged by other devices as a dynamic-address-group (DAG). With adaptive threat profiling, the Juniper ATP Cloud service acts as a feed-aggregator and consolidates feeds from SRX across your enterprise and shares the deduplicated results back to all SRX Series Firewalls in the realm at regular intervals. SRX Series Firewalls can then use these feeds to perform further actions against the traffic. This feature allows you to find systems running applications that increase the risks on your network and ensure these systems are processed through IPS and Juniper ATP Cloud for malware and virus protection1. References:

• Adaptive Threat Profiling Overview and Configuration
• Adaptive Threat Profiling Overview
• Juniper Launches Adaptive Threat Profiling, New VPN Features
• Juniper Networks Answers Who and What is On the Network with Risk-Based Access Control Capabilities and New VPN Application
• Adaptive Threat Profiling Overview | SD Cloud

You can create an exempt rule to skip detection of a set of attacks in certain traffic. You can specify the source and destination IP addresses as the match criteria for the exempt rule. This allows you to exclude traffic from specific hosts or networks from being examined by the IPS rulebase. You can also specify other parameters such as protocol, application, and attack objects for the exempt rule, but source and destination IP addresses are the most common ones. References: = Create IPS or Exempt Rules and rulebase-exempt